Anton Wilson Melbourne Learning & Resource Center
Do you want to get in touch with Anton Wilson, Melbourne Based Web Developer? Navigate the information below to make contact.
Anton Wilson Popular Posts
by Anton Wilson. The Lenovo IdeaPad 730S is exquisite no longer just for what it presents, however for what it doesn’t. not like many different laptops in the $900-and-up funds, the IdeaPad 730S doesn’t radically change right into a tablet and doesn’t...
by Anton Wilson. In early 2018, HP issued a battery don't forget after it turned into found that some of its desktop batteries might overheat and capture fireplace. on the time, HP published the steps you obligatory to make use of to investigate your in case your...
y Anton Wilson. Some HP laptops proceed to suffer from misguided batteries that may cause “fireplace and burn hurt,” in line with the U.S. purchaser Product safeguard fee. As cited by means of CNET and Tom’s Hardware, this most fresh HP battery do not forget...
Frequently Asked Questions
My computer does not turn on, what do I do now?
First check the computer’s power cord to make sure it is completely plugged into the wall socket. If you are using a plug strip, make sure it is completely plugged into the wall socket and that the power switch on the plug strip is turned on. Some plug strips also have a built in circuit breaker which usually looks like a black or red button near the power switch. Press the button to reset it and see if that solves the problem.
There is no display on the monitor, what do I do now?
Make sure the monitor is on. If no power light (green or orange light) is seen on the monitor display try pressing the power button until it comes on. If your computer monitor was on and you stepped away from the computer and upon returning it was black, it’s likely that the computer is asleep. Try moving your mouse, clicking the mouse buttons, and/or pressing any key (space bar) on the keyboard to wake it up. Make sure that the monitor is connected properly to the back of the computer.
What do I do if the image on screen is distorted or skewed?
You may receive a distorted image when the cable is loose or defective. Disconnect the video cable going from the back of the computer and verify that no pins are bent, burnt or broken. Once verified re-connect the monitor cable. If the refresh rate is not properly set the monitor may have a wavy or an appearance that lines are going down or across the monitor slowly or fast, this may also cause a flickering affect. A distorted image can be caused by magnetic or other types of interference. Verify no speakers, fans or other magnetic devices are close to the monitor.
What do I do when my computer crashes?
There are many reasons why a computer may just stop working or “freeze”. Most of the time there isn’t much we can do about it, it is a fact of life that computer programs have become so complex that occasionally users will experience problems even when performing common tasks. When your computer no longer responds to keyboard commands your best bet is to restart the computer.
What do I do if my hard disk fails to work?
As with most computer errors, your first step is to shut down your computer and restart it. This will help you determine whether or not you actually have a hard disk problem. If the disk is severely damaged then your computer will probably fail to restart properly. If this is the case then contact MCWare IT Solutions, this is a job for the professionals.
I get a 'no signal input' message, what do I do?
Verify that the monitor is properly connected in the back of the monitor as well as to the back of the computer. If the monitor appears to be connected properly, verify that a cable is not loose by disconnecting all cables that can be disconnected in the back of the monitor (generally the data cable cannot be disconnected). Next, disconnect the data cable connected to the back of the computer and then reconnect the cable. When connecting the cable in the back of the computer ensure the cable connection is tight. Most Computers will also have screw ends that can be screwed in to hold the connector in place.